Spinning metal PING Dana Chaos

Share your machining knowledge with the membership. Pictures appreciated!
AzHonker
Posts: 456
Joined: Tue Sep 30, 2014 7:53 pm
Location: Desert Hills, AzLand

Spinning metal PING Dana Chaos

Postby AzHonker » Fri Sep 02, 2016 10:35 pm

Dana you posted information in Adam's board about spinning brass horns to change the length of the throat, specifically Grover 16XX series. I've been tinkering with it some myself and the results have been less than wonderful. If you could post that information here it would be of great service. Thanks

Captofchaos
Posts: 52
Joined: Sun Dec 14, 2014 9:52 pm

Re: Spinning metal PING Dana Chaos

Postby Captofchaos » Sat Sep 03, 2016 6:46 am

My Grover project came to a standstill a while back. I PM'd you my phone no to discuss.
https://m.flickr.com/#/photos/great-american-horn-machine/7031730665/sizes/o/


Return to “Machine Shop”

Who is online

Users browsing this forum: No registered users and 1 guest